Removing Expansion Card From The Expansion Card Riser - Dell PowerEdge R450 Installation And Service Manual

Next steps
1. Install the air shroud.
2. Follow the procedure listed in
3. Install any device drivers required for the card as described in the documentation for the card.

Removing expansion card from the expansion card riser

Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in
3. Remove the air shroud.
4. Remove the expansion card
Steps
1. Pull and lift up the expansion card retention latch lock to open.
2. Hold the expansion card by its edges and pull the card until the card edge connector disengages from the expansion card
connector on the riser.
Figure 64. Removing an expansion card from the Riser 1
After working inside your
Safety instructions.
Before working inside your
risers.
system.
system.
Installing and removing system components 69