Table of Contents
Advertisement
overloading house wiring circuits that could cause a fire hazard from overheating. Never unplug the
appliance by pulling on the power cord. Always grip the plug firmly and pull straight out from the
receptacle. Repair or replace immediately all power cords that have become frayed or otherwise
damaged. Do not use a cord that shows cracks or abrasion damage along its length or at either end.
When moving the appliance, be careful not to damage the power cord.
EXTENSION CORD
Because of potential safety hazards under certain conditions, it is strongly recommended that you do not
use an extension cord with this appliance. However, if you must use an extension cord, it is absolutely
necessary that it be a UL/CUL-Listed, 3-wire grounding type appliance extension cord having a grounding
type plug and outlet and that the electrical rating of the cord be 115 volts and at least 10 amperes.
REVERSING THE DOOR SWING OF YOUR APPLIANCE
This unit has the capability of the door opening from either the left or right side. The unit is delivered to
you with the door opening from the left side. Should you desire to reverse the opening direction, please
follow the reversal instructions shown below.
7
NOTE: All parts removed must be saved to allow the door swing to be reversed.
1. Remove the plastic cover (3) then remove the bottom hinge (1) by unscrewing the four lock screws
(2). Be careful to hold the door firmly after removing the screws. (Fig. 1)
2. Gently pull down to remove the door from the right top hinge and place it on a padded surface to
avoid the risk of damage. Then remove the right top hinge (8). (Figs. 1 & 4)
3. Unscrew and transfer the stopper pin (6) to the alternate designated position of the bottom hinge.
(Fig. 2)
4. Unscrew and transfer the door adapter (4) to the opposite left position of door. (Fig. 2)
5. Pop out the cover caps on the left side of cabinet and use them to
hand side.
1 2
3
4
5
4
1
cover the screw holes on the right
7
6
Advertisement
Table of Contents
