Onkyo TX-8390 Instruction Manual page 93

Setting Item Default Value
Pairing -
Information
Device -
Status -
• Wait for a while if "Bluetooth" cannot be selected. It can be selected when the
BLUETOOTH function is activated.
„ 4. Power Management
Change the settings for the power-save function.
Setting Item Default Value
Sleep Timer Off
Setting Details
You can initialize the pairing information stored on
this unit.
Pressing ENTER when "Clear" is displayed
initializes the pairing information stored on this
unit.
• This function does not initialize the pairing
information on the BLUETOOTH-enabled
device. When pairing the unit again with the
device, be sure to clear the pairing information
on the BLUETOOTH-enabled device
beforehand. For information on how to clear
the pairing information, refer to the instruction
manual of the BLUETOOTH-enabled device.
Displays the name of the BLUETOOTH-enabled
device connected to the unit.
• The name is not displayed when "Status" is
"Ready" and "Pairing".
Displays the status of the BLUETOOTH-enabled
device connected to the unit.
"Ready": Not paired
"Pairing": Paired
"Connected": Successfully connected
Setting Details
You can allow the unit to enter standby
automatically when the specified time has elapsed.
Select a value from "30 minutes", "60 minutes" and
"90 minutes".
"Off": The unit does not automatically enter standby
mode.
Contents Connections
≫
Setting Item Default Value
Auto Standby On/Off
Auto Standby in On/Off
HDMI Standby
Through
USB Power Out Off
at Standby
93
Front Panel≫ Rear Panel≫ Remote≫
Playback Setup
≫ ≫
Setting Details
This setting allows the unit to enter standby mode
automatically after 20 minutes of inactivity without
any video or audio input. (When "USB Power Out
at Standby" or "Network Standby" is enabled, the
unit enters the HYBRID STANDBY mode which
minimizes the increase in power consumption.)
"On": The unit automatically enters standby mode
("AUTO STBY" lights up).
"Off": The unit does not automatically enter standby
mode.
• "Auto Standby" is displayed on the main unit's
display and TV screen 30 seconds before
entering standby mode.
• "Auto Standby" does not work when Zone 2 is
active.
• Default values vary depending on the regions.
Enable or disable "Auto Standby" while "HDMI
Standby Through" is on.
"On": The setting is enabled.
"Off": The setting is disabled.
• This setting cannot be set to "On" if "Auto
Standby" and "HDMI Standby Through" are set
to "Off".
• Default values vary depending on the regions.
When this function is set to "On", electricity can
be supplied to the device connected to the USB
port on the rear panel even if this unit is in standby
mode .
The USB port on the front panel does not support
power supply to a connected USB device when the
unit is in standby mode.
• When this function is set to "On", the power
consumption in standby state increases,
however, the increase in power consumption is
minimized by automatically entering the HYBRID
STANDBY mode where only the essential circuits
operate.
≫