Maintenance - Rowenta Intense Pure Air Manual

PU4020F0-PU6020F0_903452-01-V10.qxp_903452/01 12/12/14 10:06 Page16
Press Ambient light
1
2 Moderate light
3
4
TIMER / DELAYED START
If the appliance is on: you can use this button to define the operating duration. Briefly press the button
to select the number of operating hours desired (1, 2, 4 or 8) and the appliance will automatically turn
off at the end of the selected period.
If the appliance is off: briefly press the button to set the appliance to turn on in a certain number of
hours (1, 2, 4 or 8).
3D PURE AIR FUNCTION (adjustable grid)
You can adjust the position of the air outlet grid manually, as desired. For an optimum, even flow of
purified air in the room, set the angle to 45°; for maximum comfort, set the angle to 90°.

MAINTENANCE

Always switch the appliance off with the button (8) and unplug it before conducting any maintenance
operation.
You can clean the appliance with a slightly damp cloth.
IMPORTANT: Never use abrasive products which could damage your appliance's appearance.
FILTERS
Filter
Pre-filter
Active carbon filter
HEPA filter
NanoCaptur filter
This data is based on an average use of 8 hours per day at speed 2.
The recommended frequency for cleaning and replacing the filters may vary depending on the duration
of use and the operating environment.
• A "HEPA" light indicates when the HEPA filter needs to be replaced.
The 'Odor' light display indicates when the carbon filter needs replacing.
• The NanoCaptur filter contains translucent granules which change color according to the formaldehyde
absorption rate. Refer to the color chart on the inside of the panel or the filter itself to establish the filter
saturation rate.Once the saturation rate has reached its maximum, the filter must be replaced. You have
to check the filter saturation rate every six months.
• The pre-filter can be re-used: remove the dust using a vacuum cleaner or wash with water.
CAUTION:
• The appliance's efficiency can be reduced if the pre-filter is not cleaned regularly.
• Never use a pre-filter that is still damp.
• The pre-filter is the only filter which can be re-used and washed with water. The HEPA, NanoCaptur
and active carbon filters cannot be cleaned and re-used. Never wash with water.
• To replace the filters, follow the instructions in the section « Disassembling/Reassembling filters ».
16
Light up
Off
Off
Air quality indicator
Light up
Moderate light
Moderate light
Off
Action
Clean
Replace
Replace
Replace
Control panel
Light up
Moderate light
Moderate light
Moderate light
Cycles
Every 2 to 4 weeks
Every 12 months
Every 3 years
Color changing
(see Color chart on filter)