Perlick HP24Z Use & Care Manual page 13

PERLICK RESIDENTIAL UNDERCOUNTER REFRIGERATION USE & CARE GUIDE
Problem
Compartments are warmer than usual
System runs for a long period of time.
Condensation forms outside of the unit
Condensation forms inside the compartments High humidity and/or frequent door opening
TOUCH-SCREEN CONTROL OPERATION - WINE MODELS
Control preset is set to warm
Light is staying on
Condenser is dirty or obstructed
The door is open or has been opened more
frequently lately.
Internal louvers and/or the fan guard is
obstructed.
Warm product product was recently placed in
the cabinet.
Condenser is dirty or obstructed.
Door was kept open for a long time or was
opened more frequently, or warm product
was recently placed in the cabinet.
Hot day and warm room temperature
High humidity and/or frequent door opening
Door is not closing and sealing properly
Cause
perlick customer service (800)558-5592 | 13
Solution
• Lower the setpoint temperature. Refer
to changing the set point for the specific
model
• Turn the manual light switch off.
• Clean the condenser and clear
obstruction.
• Wait 24 hours and recheck the
temperature.
• Reset the preset temperature if necessary
– refer to page 5 and 6 of this guide.
• Make sure the louvers and/or the fan are
not obstructed.
• Wait 24 hours for product to chill, then
recheck the temperature.
• Clean the condenser and clear the
obstruction.
• Wait 24 hours and recheck temperature.
• Normal for the system to run more
frequently.
• Normal Operation
• Normal operation
• Make sure the door is closing properly.
Check the door seal and replace if
necessary.
• If condensation persists, contact Perlick
Technical Service at 800-558-5592