Table of Contents
Advertisement
Maintenance and Lubrication Schedule
Outer platform side plates (4 places) and sliding
platform guides (2)
Upper control arm pivot points (12)
Lower control arm pivot points (12)
Platform pivot pin bearings (4)
Transition plate ramp hinge
Inner roll stop hinge
Inner roll stop lever rollers (2) and bearings (2)
Inner roll stop slide bracket slot area (2) - front & back
Inner / outer vertical channel tapered rollers (36)
Inner / outer vertical channel outer rollers (36)
Hydraulic in/out cylinder upper pivot bushings (4)
Intermediate vertical channel (s-beam) edges (8)
Inspect inner roll stop for:
1500
Cycles
and for proper operation
Inspect microswitches for securement and proper
adjustment.
Make sure lift operates smoothly
Inspect external snap rings / e-clips:
Inspect all threaded fasteners for damage and posi-
tive securement.
Remove pump module cover and inspect:
nections for securement or damage
Page 10
Apply Door Ease to top and bottom edges of outer
platform side plates and bottom edges of sliding
platform guides. See Lubrication Diagram.
Apply Light Oil - See Lubrication Diagram
Apply Light Oil - See Lubrication Diagram
Apply Light Oil
Apply Light Oil - See Lubrication Diagram
Apply Light Oil - See Lubrication Diagram
Apply Light Oil - See Lubrication Diagram
Apply Door Ease - See Lubrication Diagram
Apply Light Oil - See Lubrication Diagram. Use
Synthetic Grease during roller replacement.
Apply Light Oil - See Lubrication Diagram. Use
Synthetic Grease during roller replacement.
Apply Light Oil
Apply Door Ease - See Lubrication Diagram
Replace damaged parts.
Switch Adjustment section
Lubricate or correct as needed.
Resecure or replace if needed.
Resecure or replace damaged fasteners. See Ex-
ploded View section for fasteners that require #242
General Purpose Blue Loctite (Braun #18822).
-
Advertisement
Table of Contents
