Table of Contents
Advertisement
Remove string or hair that may be wrapped
around the agitator.
WARNING
Be careful when removing the
agitator as the belt tension is high.
Failure to do so could result in
personal injury from the agitator
releasing quickly and snapping away.
TO REPLACE BELT
Seat the right end of agitator into nozzle
base.
Loop the new belt on the motor shaft.
Loop the other end of belt onto the belt
pulley on the left end of agitator.
To seat agitator right end, pull both end of
agitator forward and seat it into nozzle base.
To seat agitator left end, put left end of
agitator into slot in nozzle base as shown.
Press firmly, checking to see that each end
is completely inserted. And then turn agitator
making sure that belt turns freely and is not
pinched between agitator and agitator shield.
To replace the nozzle bottom plate, follow
the NOZZLE BOTTOM PLATE REMOVAL /
INSTALLATION section.
-14-
(Page 13)
Advertisement
Table of Contents
