Installation - Omega ORU50X Instructions For The Use And Care And Installation

2. INSTALLATION

Please ensure that before installing the range hood, that all power is switched off.
Installation must be in accordance to the local electrical authority and codes. This
range hood must be earthed at all times for the operators' safety.
The G.P.O. for the range hood should be positioned to enable the user to turn the
power off, to enable cleaning and any maintenance required.
Ensure that when installing the range hood, that it is protected from any
possible damage from tools etc.
Ducting for this unit must be installed in accordance to the local authority. Ensure
that the fixings used for this range hood are suitable.
Check the area where the range hood is to be fitted, to ensure that it is
structurally sound.
Before using the appliance, remove the plastic coatings protecting the
stainless steel finish.
Ensure that the wall is structurally sound, and is capable of carrying the
weight of the range hood.
It is recommended that the dimension be checked on the range hood
before installing.
The cooker hood should be placed at a distance of 65-75cm (26-30inch)
1.
from the cooking surface for the best effect.
Drill a hole in the cupboard, 490*265(mm) for model ORU50X.
2.
Make sure the distance between the edge of the hole and the edge of
the cupboard edge is at least 35mm. Take down the filter and remove the
four screws on the panel.
3 ．
4. Use random accessory tighten screws fix the hood into cabinet.
5. Use 4 screws fix the panel into body and equip the filter.
6. Install one-way valve: put the one-way valve into air outlet, Put on
the one-way valve with air outlet.
4