Operation
Operation
Spray Tip Installation
To avoid serious injury from skin injection,
do not put your hand in front of the Spray
Tip when installing or removing the Spray
Tip and Spray Tip Guard.
1. Perform Pressure Relief
Procedure, page 12.
2. Use spray tip (A) to insert
™
OneSeal
(B) into tip guard (C).
ti24653a
2. Insert Spray Tip.
ti24664a
20
C
B
A
3. Screw assembly onto gun. Tighten.
ti24652a
Spray
NOTE: If spraying oil-based or flammable
material, follow Grounding Instructions,
page 10.
When a RAC X™ FF LP Fine Finish Low
Pressure reversible spray tip is used,
spraying pressure can be lowered. Spraying
at a lower pressure results in less overspray
and reduces spray tip wear. Adjust the
sprayer pressure to minimize overspray.
ti31709a
Atomized, evenly
distributed fan pattern
Tails
3A8179B