Tannoy CVS 4 Installation Manual page 7

6.2 MECHANICAL INSTALLATION GUIDE FOR SHEET-ROCK (PLASTER BOARD) CEILINGS
1
Mark the cut-out area on the ceiling by tracing around the template provided.
Cut out the hole in the ceiling using a circular saw or pad saw, then slide the
2
C-ring into the ceiling, aligning it over the cut-out hole.
3
Go to section 7 for wiring and set-up instructions then return to point 4 below.
4
Slide the speaker assembly through the hole and turn the screws to extend the mounting
wings. Tighten the screws until a firm grip is achieved.
If using a power driver, Tannoy recommends a torque setting of 1.5Nm.
DO NOT OVERTIGHTEN!
5
Connect a Secondary Support Line to safety tab. Some construction codes require use
of this secondary support point, which should connect to a separate secure support point
using a suitable support line. Consult construction codes in your region.
6
Insert grille by pushing it onto the speaker.
7