Installing Foot Bracket (Or Model Only); Installing Wall Bracket - Generac Power Systems PWRcell M3 Installation Manual

Installing PWRcell Battery

Installing Foot Bracket (OR model only)

Mount foot bracket to wall with the following procedure:
A template is included and will help locate the holes for
both Wall and Foot Brackets.
•
Before finalizing horizontal location for upper and
lower wall mount, ensure all bolts will line up with
wall studs.
•
Lower mount should maintain of distance of 3 in
minimum from grade.
•
See 4-1. Install the lower wall mount with flat
Figure
washers and lag bolts (A).
NOTE: Do not install the top bolts at this stage. This will
inhibit foot bracket installation.
A
Figure 4-1. Install Lower Wall Mount
•
See Figure 4-2. Slide foot bracket (A) into bottom
bracket (B) making sure underside of pockets clear
bottom bracket
installation is achieved by lining up the top edge of
lower wall mount to the bottom edge of wall flange
part of foot bracket.
A
Figure 4-2. Insert Foot Bracket into Lower Mount
•
See 4-3. Use flat washers and lag bolts (A)
Figure
to secure top of lower mount.
A
Figure 4-3. Install Top Bolts in Lower Wall Mount
16
011153
before engagement.
B
011156

Installing Wall Bracket

•
See Figure
mm) off the floor for IR installations.
•
Each horizontal brace requires a minimum of two
fasteners. Four total fasteners are required. All
fasteners must engage structural materials by a
minimum of 1.5 in. All fasteners must be field
supplied. Installer must ensure that fasteners
selected are appropriately rated for this application.
For OR installations, mount wall bracket to wall with the
following procedure:
•
See
Figure
installed make sure the mounting holes to the lower
Proper
wall mount (B) line up with the upper wall mount (A)
for 16 in on center studs (C). Four screws are
required in lower wall mount.
•
Be sure to maintain 34 7/8 in (886 mm) spacing
between bottom holes in upper wall mount and
bottom holes in lower wall mount.
A
011155
4 3/16 in
(106.8 mm)
Figure 4-5. Lower and Top Bracket Alignment
Installation Manual for Generac PWRcell Battery
4-4. Bottom edge (A) is 29-5/8 in (752
A
Figure 4-4. Wall Bracket
4-5. Once the lower wall mount is
B
16 in
(406.4 mm)
C
009920
17 3/16 in
436 mm
34 7/8 in
(886 mm)
011154