Craftsman CMHT77630 Instructions Manual page 13

Using the Laser with the Bracket
A bracket (Figure ) is included with the laser so you
G
can easily attach the laser to a stud, ceiling grid, or pole.
1. Securely attach the laser to the bracket.
• Using the 1/4-20 thread on the bottom, side, or
back of the laser (Figure
on the 1/4-20 thread on the bracket arm (Figure
).
G 1
• Turn the laser knob (Figure
the laser on the 1/4-20 thread on the bracket arm.
2. If needed, change the height or position of the laser on
the bracket.
• Turn the adjustment knob (Figure
clockwise to loosen the bracket arm.
• Slide the bracket arm up or down to the desired height
(Figure ). To change the bracket from 90° to
G 4
180°, slide the bracket arm to the top of the bracket
and then flip the arm to the right (Figure
• Turn the adjustment knob (Figure
lock the bracket arm in place.
3. Use the bracket's clamp (Figure
in place on a stud, ceiling grid, or pole.
• If necessary, rotate the clamp so it is positioned at
the correct angle for attaching to the object. While
holding the bracket arm with one hand, use your
other hand to turn the clamp (Figure
• Position the bracket's clamp around the stud,
ceiling grid, or pole.
• Turn the clamp knob (Figure
the clamp is tight around the object and the bracket
is held in place.
), position the laser
C
) clockwise to lock
G 2
) counter-
G 3
).
G 5
) clockwise to
G 3
) to hold the laser
G 6
).
G 7
) clockwise until
G 8
Using the Laser with Other Accessories
WARNING:
Since accessories other than those offered by
CRAFTSMAN have not been tested with this
®
laser, use of such accessories with this laser
could be hazardous.
Only use CRAFTSMAN accessories that are
®
recommended for use with this model. Accessories that
may be suitable for one laser may create a risk of injury
when used with another laser.
The laser is equipped with a 1/4-20 female thread on
the bottom, side, and back (Figure
current or future CRAFTSMAN
Other recommended accessories for use with this laser
are available at extra cost from your local dealer or
authorized service center. If you need assistance locating
any accessory, please contact your nearest CRAFTSMAN
service center or visit our website: www.CRAFTSMAN.
com.
Maintenance
• When the laser is not in use, clean the exterior parts
with a damp cloth, wipe the laser with a soft dry cloth
to make sure it is dry, and then store the laser in the
kit box provided.
• Although the laser exterior is solvent resistant, NEVER
use solvents to clean the laser.
• Do not store the laser at temperatures below -5 ˚F
(-20 ˚C) or above 140 ˚F (60 ˚C).
• To maintain the accuracy of your work, check the laser
often to make sure it is properly calibrated.
• Calibration checks and other maintenance repairs may
be performed by CRAFTSMAN service centers.
) to accommodate
C
accessories.
®
E
13