Advertisement
• Secure gland mount cap (5) to the replacement LED light by turning to the right and tighten
to ensure there is a water tight seal, and once again check "o" ring is proper tting.
• Re t black power cable gland nut (6) and tighten to ensure proper sealing and locking the
gland mount cap (5) to correct position.
The replacement LED light is now ready to be re tted to the outer ange body (7) already
secured into the breglass pool/spa wall. Ensure to carefully push the 1m coiled power cable
into the outer ange niche body (7) and re t the new replacement LED light & lens assembly (1)
and secure to the light Niche housing (7) by turn till tight to the right.
Congratulations, reconnect power to your light at the circuit breaker and your new Waterco
replacement LED light is ready for use.
TROUBLE SHOOTING
FAULT
Light not operating
Light very dim and
pulsating
Main house fuse
blows when light
switched on
POSSIBLE CAUSE
- Fuse in transformer blown.
- No power to transformer.
- Fault in electrical wiring.
- Mismatch of lamp and
transformer ratings.
- Damaged wiring/ connectors.
- Faulty transformer
- Damaged cable
- Incorrect electrical installation.
Rainbow Pool Products
PO Box 2388, Mansfield Qld 4122
Telephone STD 61-7-3849 5385
Facsimile STD 61-7-3849 5384
Email: info@rainbowpoolproducts.com.au
Web: www.rainbowpoolproducts.com.au
Waterco Britestream LED Fibreglass Niche Pool Lights
REMEDY
- Replace fuse.
- Check main fuses in switchboard.
- Electrician to check.
- Fit correctly rated transformer*.
- Replace wiring/ connectors.
- Call electrician to check
installation.
I
Advertisement
