Advertisement
LED FIBREGLASS POOL/SPA LIGHT COMPONENT
IDENTIFICATION
Light Lens
INSTALLATION
• Locate the ideal position within the breglass pool/spa wall surface that best suits the lights
installation ensuring this location is not more than 600mm below top of coping.
• Mark this position and using a 2.5" (63.5mm) holesaw drill a hole in the breglass pool/spa
wall that will allow the light to be tted.
• Remove the 2" BSP threaded nut, ange (outer) & outer gasket from the lights body and the
20m power cable.
• Thread the 20m power cable from the inside of the breglass pool/spa through to the outside
of the pool/spa and insert the pool/spa light body into the 2.5" (63.5mm) hole.
Note: The inner gasket must be positioned between the pool/spa light lens and the breglass
pool/spa surface.
• Thread the 20m power cable into the outer gasket, ange and 2" BSP nut and install on the
exposed threaded light body. Tighten the 2" nut suf ciently to ensure the light assembly is
properly secured to the breglass pool/spa wall and will not leak water.
Note: Inspect and repair as necessary the breglass pool/spa walls to ensure the inner & outer
gaskets are able to provide a water tight seal.
Note: It is recommended that the pool/spa light be fully immersed in water & the installation is
inspected for leaks prior to back lling the pool/spa light/s installation area.
• The 20m power cable is now ready for connection to a Waterco single or multi connect pool
light transformer.
Note: For further protection of the power cable the use conduit is an option.
2 x Gaskets
1 x 2" BSP Thread Nut
Light Niche Body
Gland Nut & Fitting
Advertisement
