Advertisement
Connecting replacement LED light
The replacement LED lights are available as white, blue or multicolour RGB models and are
supplied as a complete light assembly with the additional components as follows:
2 x Quick connect spade electrical connectors (4).
1 x gland mount cap (5) with black power cable gland nut and black gland (6).
2 x "o" rings (2 & 3).
1 x Bottle of natural lanoline.
• If not removed, inspect the two existing quick connect electrical connectors (4) on the two
exposed wires of the power cable. These should be replaced if there is any suspicion of
damage.
• If required remove the two quick connect electrical connectors (4) and replace with the 2 x
replacements supplied with the LED replacement light.
Note: The exposed wires from the power cable conduit required length is approx 50mm.
Note: The electrical components inspection and installation of the pool/spa lights should
be carried out by a suitably qualified persons (e.g. registered pool builder and/or qualified
electrician), in accordance with AS/NZS 3000:2007 standards.
• Remove the gland mount cap (5) from the rear of the LED replacement light (unscrew to left).
The black power cable gland nut and black gland (6) are tted into the gland mount cap (5).
Unscrew the black power cable gland nut (5) and place over the power cable and push the
power cable through the black gland (6) and gland cap (5).
Note: Gland nut (6) should not be fully tightened. This will allow for adjustment of power cable.
• If necessary, ensure the 2 x exposed power wires to the replacement LED pool/spa light
are approximately 50mm and then strip the blue and brown wires insulations approximately
10mm. Crimp the two quick connect spade connectors (4) to the stripped 10mm section of
the blue and brown wires.
• Connect the two quick connect spade connectors (4) to connectors provided in the rear cup
section of replacement LED light.
• Squeeze natural lanoline from supplied bottle into rear cap of replacement LED light
completely covering the two quick connect spade connectors and ll to top.
Hint: Submerge the bottle of lanoline into a suitable size vessel and add temperate/warm
water, this will help to soften the lanoline for easier ow and ensure the rear cap is completely
full of lanoline for proper protection of the two quick connect spade connectors.
Slide gland mount cap (5) with black gland (6) to the correct position on the power cable
conduit. Re t the two new "o" rings (2 & 3) to the rear of the replacement LED light and
internally of the gland mount cap (5).
Note: Ensure that both "o' rings are properly tted into the gland mount cap (5) "o" ring seats/
grooves.
Advertisement
