Table of Contents
Advertisement
Laird WB45NBT
Reference Guide
2. Connect the USB cable to the computer and then to the WB45NBT.
3. Install the AT91 USB CDC driver by following these steps:
Found New Hardware
a. When the
No, not this time
choose
. Click Next.
Install from a list or specific location (Advanced)
b. Select
Don't search. I will choose the driver to install
c.
Select
Have Disk
d. Select
. Click Next.
Browse
e. Select
.
f.
Navigate to C:\Program Files\ATMEL Corporation\SAM-BA v2.10\drv
Figure 2: Installing the AT91 Driver
g. Select the file named atm6124_cdc.inf (Summit's driver file) and click Open.
h. Select OK. A dialog appears, noting the driver is not signed.
i.
Select Continue Anyway.
j.
Wait for the driver to install and then select Finish.
The driver installs itself as a virtual COM port on the PC. This COM port shows up in the device manager under
Windows.
Note:
Because this COM port will be needed when starting the SAM-BA utility, remember what COM port is
assigned to this connection.
Software Requirements
Operating System: Windows XP 32-bit
Images listed in Boot Image Description section (available from Summit Data Communications)
SAM-BA flash utility provided by Atmel. This utility is available from Atmel's web site:
http://www.atmel.com/dyn/products/tools_card.asp?tool_id=3883
One modification to the SAM-BA utility configuration file is required. SAM-BA must be configured for the 16-bit
hardware connection between the AT91 CPU and the SDRAM on the WB45NBT module. Because the configuration
file specifies a 32-bit connection by default, this setting must be changed.
Embedded Wireless Solutions Support Center:
http://ews-support.lairdtech.com
www.lairdtech.com/wi-fi
dialog pops up and asks if Windows may connect to windows update
. Click Next.
. Click Next.
(Figure
21
© Copyright 2016 Laird. All Rights Reserved
2).
Americas: +1-800-492-2320
Europe: +44-1628-858-940
Hong Kong: +852 2923 0600
Advertisement
Table of Contents
