Troubleshooting - Dexter Laundry 800AG2-125.5AB1 Instruction Manual

BR
11. TRACEABILITY NUMBER /
EN
SERIAL NUMBER
The Traceability Number/Serial Number will be showed in the label.

12. TROUBLESHOOTING

PROBLEM
Machine does
not start.
Motor does
not reach full.
Motor stalls,
blows fuses,
or trips circuit
breakers.
Motor
overheats.
CAUSE
1.Power cord not plugged in.
2.Power cord is damaged.
3.Circuit breaker is tripped.
4.Switch is locked at "OFF"
conditions.
1. Voltage from power
source.
2. Circuit is overloaded.
3. Motor burned out.
1. Switch is defective.
2. Carbon brush is wornout.
3. Voltage from source is
low.
4. Fuses or circuit breakers
are wrong size or defective.
1. Motor is overloaded.
2. Grinding disc is being fed
into work too fast.
3. Air vents become
obstructed.
SOLUTION
1. Plug in cord.
2. Replaced at authorized
service center.
3. Reset circuit breaker.
4. Restart the tool.
1. Request a voltage check.
without anything else on circuit.
3. Have tool serviced and
request a voltage check.
1. Replaced at authorized
service center.
2. Replace at authorized
service center.
3. Request a voltage check.
4. Replace with a correct
circuit breaker or fuses.
1. Request a voltage check.
2. Feed grinding into work
slower.
3. Clean air vents.
38