Con@Ctivity Via A Direct Wifi Connection (Con@Ctivity 3.0); Reattempting The Connection - Miele DAD 4840 Operating And Installation Instructions

Con@ctivity via a direct WiFi
connection (Con@ctivity 3.0)
Prerequisite:
- WiFi enabled Miele hob
If you do not have a home network, you
can establish a direct connection
between the hob and the cooker hood.
 With the deflector plate retracted,
touch the On/Off switch .
All symbols light up with reduced
brightness.
 Press and hold the run-on option
control  until the grease filter 
and charcoal filter  symbols light
up.
 Touch 3.
The deflector plate extends.
2 will light up constantly, 3 will flash.
The cooker hood will be ready for
connection in the next 2 minutes.
Before using for the first time
 Start the WiFi connection on the hob.
For further details, see the hob
operating instructions.
When successfully connected, 2 and
3 will light up constantly.
 Quit connection mode on the cooker
hood by touching the run-on option
control .
Con@ctivity is now activated.
With a direct WiFi connection, it is not
possible to connect the hob and the
cooker hood to a home network.
Should this be required at a later date,
the WiFi connection between the hob
and the cooker hood must be
disconnected (see "Sign out of WiFi").

Reattempting the connection

If it is not possible to connect, 2 and 3
flash or the cooker hood cancels the
process.
 Disconnect the connection to the
cooker hood (see "Signing out of
WiFi") and to the hob.
 Attempt to make the connection
again.
23