Operating and installation instructions Downdraft extractor To prevent the risk of accidents or damage to the appliance, it is essential to read these instructions before it is installed and used for the first time. en-AU, NZ M.-Nr. 12 048 290...
Recirculation mode Plug&Play ............... 16 Before using for the first time ................17 Selecting extraction mode or recirculation mode..........17 Setting up Miele@home ..................18 Connecting via the App.................. 18 Connecting via WPS ..................20 Signing out of Wi-Fi (reset to factory settings) ..........21 Setting up Con@ctivity ..................
Contents Energy saving tips ..................... 33 Cleaning and care ..................... 34 Housing ....................... 34 Important information for appliances with stainless steel surfaces ....34 Grease filters and edge extraction panel............. 35 Removing the panel ..................36 Cleaning the drip tray ..................37 Inserting the panel..................
Caring for the environment Disposal of the packing Disposing of your old material appliance The transport and protective packaging Electrical and electronic appliances has been selected from materials which often contain valuable materials. They are environmentally friendly for also contain specific materials, disposal, and can normally be recycled.
It must only be used to extract vapours and remove odours from cooking. Any other usage is at the owner's risk. Miele cannot be held liable for damage resulting from incorrect or improper use or operation. This appliance is not intended for use by persons (including...
Warning and Safety instructions Safety with children Young children must not be allowed to use the rangehood. Older children may only use the rangehood if its operation has been clearly explained to them and they are able to use it safely. They must be able to understand and recognise the possible dangers caused by incorrect operation.
The protective measures provided in the installation and in this Miele product must also be assured in their function and operation in isolated operation or in non-mains synchronous operation, or replaced with equivalent measures in the installation.
The lamps are a built-in component of the lighting. Replacement lamps may only be installed by a Miele authorised technician. During installation, maintenance and repair work, the appliance must be disconnected from the mains electricity supply.
Warning and Safety instructions Using at the same time as other heating appliances that depend on the air from the room Danger of toxic fumes! Great care should be taken when using the rangehood in the same room or the same area of the house as another heating appliance that depends on the air from the room.
Warning and Safety instructions In order to ensure safe operation and to prevent gases given off by a heating appliance from being drawn back into the room, when the rangehood and the heater are both operated simultaneously, an underpressure in the room of 0.04 mbar (4 Pa) is the maximum permissible.
Warning and Safety instructions Correct use Risk of crushing! Do not reach into the travel area of the deflector plate as it moves up or down. Open flames are a fire hazard! Never use an open flame under the rangehood. To avoid the danger of fire, do not flambé...
Warning and Safety instructions Correct installation To determine whether a rangehood may be operated above your cooking appliance, please refer to the information provided by the appliance’s manufacturer. The downdraft extractor must not be installed next to solid fuel stoves.
Accessories and spare parts Use only genuine original Miele spare parts. If spare parts or accessories from other manufacturers are used, the warranty will be invalidated, and Miele cannot accept liability. ...
Guide to the rangehood a Control panel b Retractable deflector plate c Cooktop lighting d Edge extraction panel e Drip tray f Charcoal filter Single-use or reactivatable charcoal filters Optional accessory for recirculation mode g Grease filter h Exhaust connection i Sensor for switching the rangehood on and off j Sensors for switching the fan on and off and for setting the fan power level k Sensor for the run-on function...
Description of the functions Depending on the model of the Recirculation mode rangehood, the following options are (with conversion kit and charcoal filter available: as optional accessories) Air extraction mode The air is drawn in via the edge extraction panel and cleaned first by the The cooking vapours are drawn in by grease filters and then by charcoal the rangehood.
Before using for the first time Selecting extraction mode or Activating/Deactivating recirculation mode Plug&Play Touch the On/Off sensor . The rangehood can be operated with either extraction mode or recirculation All symbols light up with reduced mode. The power of the fan is brightness.
Play Store™ free of charge (only operate the rangehood via the Miele functional in selected countries). App. If your Miele cooktop is connected to a home Wi-Fi network, you can control the rangehood automatically via the Con@ctivity function. Before installing the rangehood in its...
Before using for the first time With the deflector plate retracted, To log in you will need: touch the On/Off sensor . 1. Your Wi-Fi network password All symbols light up with reduced 2. Your rangehood password brightness. Press and hold the run-on option control ...
2 will light up constantly, 3 will flash on Useful tip: If your Wi-Fi router does not and off. support WPS, please connect via the Miele App. The Wi-Fi connection must be started on the rangehood at the same time as on the Wi-Fi router.
Before using for the first time Signing out of Wi-Fi (reset to factory settings) Touch the 1 control. To set up a new Wi-Fi connection, the existing Wi-Fi connection must first be disconnected. With the deflector plate retracted, 2 will light up constantly, 3 will flash on touch the On/Off sensor .
Setting up Con@ctivity network (Con@ctivity 3.0) Con@ctivity is the direct communication system between an electric Miele Prerequisites: cooktop and a Miele rangehood. It - Home Wi-Fi network enables the rangehood to operate automatically depending on the - Wi-Fi enabled Miele cooktop operational state of a Miele cooktop ...
(Con@ctivity 3.0) cooktop. For further details, see the cooktop operating instructions. Prerequisite: - Wi-Fi enabled Miele cooktop If you do not have a home network, you When successfully connected 2 and 3 can establish a direct connection will light up constantly.
Operation (automatic mode) Risk of crushing! Do not reach into the travel area of the deflector plate as it moves up or down. When Con@ctivity is active, the rangehood always operates in automatic mode (see “Before using for Examples for power levels 1 to B the first time –...
Operation (automatic mode) Cooking process Leaving automatic mode temporarily For example, you switch on a cooking zone at the highest power level to To leave automatic mode temporarily heat a pan for frying. After approx. during cooking: 10 seconds to 4 minutes, you then ...
Operation (automatic mode) You can also operate the rangehood manually for a complete cooking process. To do so switch the rangehood fan on before the cooktop. If the rangehood fan and the cooktop have been switched off for at least 30 seconds after cooking, automatic mode will resume next time the cooktop is switched on.
Operation (manual mode) Selecting the second Booster level Risk of crushing! When you select the Booster level, Do not reach into the travel area of the B symbol lights up. To increase the deflector plate as it moves up or the power level further, touch B down.
Operation (manual mode) - If you touch the run-on control Switching on and dimming the again, the fan will remain switched on cooktop lighting ( will go out). The cooktop lighting can be switched on and off and dimmed independently Switching the fan off of the fan.
Operation (manual mode) Retracting the deflector plate Touch the On/Off sensor . The fan and the cooktop lighting are switched off. All symbols go out. The deflector plate retracts. Automatic retraction If you switch off the fan and the lighting when the deflector plate is extended, the deflector plate will automatically retract after 1 minute.
Changing settings Touch the On/Off sensor . All settings are made with the rangehood switched off. All symbols light up with reduced Switch off the fan and the lighting brightness. and retract the deflector plate. Press and hold the run-on option control ...
Changing settings Altering or deactivating the Deactivating Power charcoal filter operating hours management counter Keep in mind that deactivating this function may increase energy Charcoal filters are needed for consumption. recirculation mode. You can set the operating hours counter Activating/deactivating Power to suit the type of cooking you do.
Changing settings All the indicator lights will go out. If you do not confirm your selection of setting within 4 minutes, the rangehood will revert to the previous setting. Buzzer for the sensors When a function is selected with the sensors, a short buzzer will sound for confirmation.
Energy saving tips This rangehood operates very efficiently cooking vapours in the direction of and economically. The following will the extractor ensure optimal help you to save even more energy extraction. when using it: - Clean or change the filters at regular intervals.
Cleaning and care Removing the panel and grease Grease filters and edge filters extraction panel Opening the panel Fire hazard! With the deflector plate retracted, Oversaturated grease filters are a fire touch the On/Off sensor . hazard. Clean the grease filters at regular ...
Cleaning and care Cleaning the grease filters in the dishwasher Place the grease filters upright or slightly inclined in the lower basket. Ensure the spray arm is not obstructed. Use a standard household dishwasher detergent. Select a dishwasher programme with a wash temperature between 50 °C and 65 °C.
Cleaning and care Cleaning the panel Follow the instructions under “Housing”. The panel is not suitable for cleaning in a dishwasher. When removing the filters and panel for cleaning, also clean off any residues of oil or fat from the now accessible housing to prevent the risk of these catching fire.
These are designed to absorb cooking odours. Charcoal filters are available to order via the Miele online shop (see the end of this booklet for contact details) or directly from Miele. The part number of the charcoal filter ...
Cleaning and care The operating hours counter will remind you to replace the charcoal filters by lighting up the charcoal filter symbol . Resetting the charcoal filter operating hours counter After changing the charcoal filters, the operating hours counter needs to be reset.
With the help of the following guide, minor faults in the performance of the appliance, some of which may result from incorrect operation, can be remedied without contacting Miele. This will save you time and money because you won't need a service call.
*INSTALLATION* Installation Before installation Before installation, it is important to read the information given on the following pages as well as the “Warning and Safety instructions” at the beginning of this booklet.
*INSTALLATION* Installation a Stepped cut-out for flush-fit installation in stone worktops (granite, marble) b Ensure that materials are sufficiently stable. c Cut-out off-centre d The minimum dimension is required if flat ducting is laid under the cabinets or the DUU 600 recirculation box is used. Exhaust connection 150 mm.
*INSTALLATION* Installation a Exhaust air with flat ducting and DMK 150-1 wall box b Recirculation with flat ducting and DUU 600 recirculation box c Plug&Play operation with DUP 150 conversion kit During Plug&Play operation, ensure sufficient ventilation of the plinth area, e.g. through gaps in the plinth panel.
If the exhaust air is ducted through an - If the ducting has flaps, these must outside wall, a Miele wall vent or a be opened when the rangehood is Miele roof vent (available as an optional switched on.
Connecting the rangehood to multi- provided in the domestic installation socket adapters or extension cables and in this Miele product must also be can overload the cables. assured in their function and operation For safety reasons, do not use an...
Service Contact in case of fault In the event of any faults which you cannot remedy yourself, please contact Miele. You can book a Miele customer service call-out online at www.miele.com.au/service or www.miele.co.nz/service. Contact information for Miele can be found at the end of this booklet.
Technical data Fan motor 180 W Deflector plate motor 60 W Cooktop lighting 11.2 W Total rated load 251.2 W Voltage, frequency AC 230 V, 50 Hz Fuse rating 10 A Mains connection cable length 1.5 m Weight 34 kg Wi-Fi module Frequency band 2.400–2.4835 GHz Maximum transmission power < 100 mW Optional accessory for recirculation mode Charcoal filter set DKF 30-P or DKF 30-R (reactivatable).
183 Featherston Street Miele Experience Centre South Melbourne: Wellington 6011 206-210 Coventry Street South Melbourne, VIC 3205 0800 464 353 (0800 4 MIELE) Miele Experience Centre and Office Sydney: www.miele.co.nz 3 Skyline Place Frenchs Forest, NSW 2086 Miele Experience Centre and Office Brisbane:...
DAD 4840, DAD 4940 en-AU, NZ M.-Nr. 12 048 290 / 00...