Precautions - Icom IC-M88 Instruction Manual

PRECAUTIONS

R DANGER! NEVER
tery pack. Also, current may flow into metal objects such as
a key, so be careful when placing the battery packs (or the
transceiver) in bags, and so on. Simply carrying with or plac-
ing near metal objects such as a key, and so on, may cause
shorting. This may damage not only the battery pack, but also
the transceiver.
R DANGER!
Use and charge only specified Icom bat-
tery packs with Icom transceivers or Icom chargers. Only
Icom battery packs are tested and approved for use with Icom
transceivers or charged with Icom chargers. Using third-party
or counterfeit battery packs or chargers may cause smoke,
fire, or cause the battery to burst.
R DANGER!
Use only HM-168IS
Only HM-168IS is tested and approved for use with the trans-
ceiver. Using third-party or counterfeit microphone may pre-
sent a risk of fire or explosion.
R DANGER! NEVER
unshielded electrical blasting caps or in an explosive atmo-
sphere.
RWARNING! NEVER
the antenna is closer than 2.5 cm (1 inch) from exposed parts
of the body, especially the face or eyes, while transmitting.
short the terminals of the bat-
speaker microphone
operate the transceiver near
hold the transceiver so that
CAUTION: NEVER
source other than the products specified by Icom. Such a
connection will ruin the transceiver.
CAUTION: MAKE SURE
tery pack and jack cover are securely attached to the trans-
ceiver, and that the antenna and battery pack are dry before
attachment. Exposing the inside of the transceiver to dust or
water will result in serious damage to the transceiver.
After exposure to water, clean the battery contacts thor-
oughly with fresh water and dry them completely to remove
any water or salt residue.
DO NOT
place or leave the transceiver in direct sunlight
or in areas with temperatures below –20°C (–4°F) or above
. +60°C (+140°F): Marine, below –30°C (–22°F) or above
+60°C (+140°F): LMR.
DO NOT
use harsh solvents such as Benzine or alcohol
when cleaning, as they will damage the transceiver surfaces.
DO NOT
push [PTT] when not actually intending to transmit.
DO NOT
modify the transceiver. The transceiver warranty
does not cover any problems caused by unauthorized mod-
ification.
connect the transceiver to a power
the flexible antenna, bat-
iv