UltraSecure UltraCOM2 Instruction Manual page 4

Handset
23
1. The supplied Lithium polymer battery pack is already installed in the handset. To replace
battery, press down the lock button 18 and slide open the battery door, take out the battery
and disconnect from to socket 20 .
2. With the handset switched on, place it into the charger stand.
3. Plug in the supplied AC switching power supply into an AC outlet and connect its output plug
to the DC jack 23 located at the back of charger stand.
4. The charging indicator 22 should light up red during charging process. Adjust the position of
handset in charger stand in case this indicator does not light up. During charging, the
segments inside battery level icon P
5. The battery pack should be fully charged up within 4 hours when used for the first time. All
segments inside the icon P
6. Now the unit is ready for operation. Either take out the unit or keep placing it in the charger
stand will cause no damage to the battery. In the latter case, when the battery is being
consumed and voltage falls to a certain level, the charger stand will automatically charge up
the battery. The segments inside the icon P
charging.
CAUTION : BESURE THE BATTERY IN HANDSET IS RECHARGEABLE TYPE BEFORE YOU
PLACE IT IN THE CHARGER STAND, OTHERWISE EXPLOSION MAY RESULT.
20
18
TO AC OUTLET
will flash in turn.
will shown up and remain steady.
4
22
will flash in turn whenever the unit is under
-