Operation - UltraSecure UltraCOM2 Instruction Manual

OPERATION

1. Switch on the handset by a long press (over 3 seconds) of the Power ON/OFF button 12
Press the same button again in case you want to switch off the unit.
2. The LCD screen will show up. In case the self battery low icon O
the battery has run down and need to be recharged by placing the unit into the charger stand.
During charging, the segments inside the battery level icon P
unit is switched on or off. To protect battery, if the unit is not being re-charged when the icon
O shown up, it will be switched off automatically after 10 minutes.
3. To select the different methods of incoming call alert, press and hold the Volume Up/Down
buttons 16 & 17
16 or Down button 17
up button 12
Depending on your selection, either one of the icons F to L will be shown on the screen. Note that
in case you select a combination with vibrating alert, the battery will run down more easily.
5. During conversation, the sound volume heard through the speaker 19 can also be adjusted
using buttons 16
Please note the loudness of door chime is fixed and cannot be adjusted.
7. Make sure there is power supply to the caller unit (either by 12V DC or alkaline batteries). Now
press the Call button 1
flashing. Until a handset answers the call, the ding-dong tone will be heard periodically, remind-
ing the visitor to keep waiting. In case there is no answer after 20 seconds, the caller unit ends
the call by itself and the Call indicator 4 goes off. Press the Call button
call again.
N.B. In case there are two caller units (frontgate and backgate), only the unit whose call button
1 is first pressed will send out a call signal to handset, the remaining unit will keep in
standby mode until the conversation is over. If its call button 1
period, two "Be-Be" sound will be heard and the call indicator
ing the unit is under standby mode.
8. Once the call is being answered, the Call indicator 4 will light up steady and the ding-dong tone
stops ringing. Conversation can now be conducted.
9. Upon receiving a call, either icon A
call is from the front gate or back gate (in case you have purchased an optional caller unit for
back gate). The handset can answer the call by pressing the Answer button 11
reception mode icon D
simultaneously for 2 sec to enter the selection mode. Use the Volume Up
to choose one of the seven alert methods, shortly press the Hang
to confirm your selection and return to normal operation mode.
& 17 and the speaker volume icon Q
, a ding-dong tone will be heard and the Call indicator 4 starts
will show up in LCD.
or icon B appears on the screen, depending the
10
appears and an alarm heard,
will flash in turn irrespective the
will change correspondingly.
1 to initiate the
is pressed during this
4 flashes for two times, indicat-
.
and the