Table of Contents
Advertisement
18. Transfer drill the upper two indicated mounting
P
hole locations
using a drill and 11/32" (9mm)
drill bit. After drilling secure with provided
h
j
fasteners
and
from the inside to the outside as shown.
IMPORTANT
Ensure the locking nuts are on the outside of the
tunnel. Track damage may occur if fasteners are
installed opposite as shown.
19. Install the stop bumper
the winch rope as shown by first threading the
winch rope through the stop puck and then
attaching the winch hook onto the end of the rope
U
using the clevis
and cotter pin
being sure to insert the bolts
y
and winch hook
V
.
Instr 9927951
20. Replace seat and any other previously removed
accessories.
21. Your Integrated Winch Kit comes with a Lock and
Ride Bag to store the winch accessories in. If you
do not have a rear cargo box place the winch bag
onto the rear cargo rack and line up the lock and
ride anchors with the front two lock and ride holes.
Insert them fully into the holes and cam over the
lock and rides to secure the bag into position.
If you do have the rear cargo box, the lid of the
cargo box is specifically designed to hold the bag
and its contents. Simply open the cargo box lid
and insert the bag in the opening on the lid.
22. Check to ensure all tools are accounted for and all
steps have been completed as required.
u
onto
Rev 02 2017-11
Page 7 of 12
Advertisement
Table of Contents
