Table of Contents
Advertisement
10. Install red positive (+) battery harness cable along
with all other required red positive (+) cables with
new longer battery bolt and threaded battery post
block that was provided with your kit to the positive
(+) battery terminal. Then install the black negative
(-) battery harness cable and all other required
black negative (-) cables to the negative (-) battery
post with new provided battery connection
hardware.
When BOTH battery cables are disconnected
ALWAYS reconnect AND tighten red positive (+)
battery cable to battery FIRST. Failure to comply will
result in a high current electrical arc, and may result
in battery explosion, if tool touches grounded frame.
Death or serious personal injury may occur.
Once all cables are securely fastened to their
respective terminals reinstall the battery cover
11. Reinstall rear cargo platform and torque all ten
rear cargo platform fasteners to specifications
listed below.
TORQUE
8.5 Ft. Lbs (12 Nm)
WARNING
Instr 9927951
12. Secure the electrical connector portion of the
battery harness to the rear cargo platform by fully
inserting the well nuts
mounting holes then placing spacers
position as shown and securing the connector
using provided bolts
If Receiver Hitch Kit PN 2882795 has been
previously installed skip steps 12-13.
13. Next you will need to remove the standard rear
L
hitch
from the vehicle as shown. Discard
fasteners as they will be replaced with fasteners
provided with the winch kit.
K
.
Rev 02 2017-11
Page 5 of 12
l
into the previously drilled
1(
into
2)
.
NOTE
Advertisement
Table of Contents
