Kohler 1031338 Service Kit Instructions

Handle kit

SERVICE KIT INSTRUCTIONS

Handle

Remove the Old Handle

NOTE: The faucet illustrated may look different than your actual

product. These instructions apply to all products that use this kit.

Remove the housing setscrew from the back of the faucet

housing using a 2.5 mm hex wrench.

Use a 2.5 mm hex wrench to remove the handle screw.

Remove the handle.

CAUTION: Risk of personal injury. Scalding may result if the

limit stop is not reinstalled properly.

NOTE: The water temperature does not need to be adjusted if the

water temperature is below 105∞ F (41∞ C).

NOTE: Use a thermometer rated for 120∞ F (49∞ C) or greater.

NOTE: When using a tempered water supply, install the

vandal-resistant plug button.

1034576-9-B

Handle

Screw

Handle Kit

1031338

1047233

Limit

Stop

Housing

Setscrew

Table of Contents

Do you have a question about the 1031338 and is the answer not in the manual?

Page 1 NOTE: The water temperature does not need to be adjusted if the water temperature is below 105∞ F (41∞ C). NOTE: Use a thermometer rated for 120∞ F (49∞ C) or greater. NOTE: When using a tempered water supply, install the vandal-resistant plug button. 1034576-9-B © 2005 Kohler Co.
Page 2 Using the handle, adjust the water to the desired temperature. Remove the handle screw using the supplied 2.5 mm hex wrench. Press the vandal-resistant plug button and firmly into place. 1034576-9-B © 2005 Kohler Co.

1047233