Advertisement
9. Attach the Crank (E) to the Pole (B) using a
5/8" X 5" Hex Bolt (Q) and 5/8" Lock Nut (P).
Attach the other end of the Crank (E) to the
Lower Arm (C) with a 5/8" X 12" Hex Bolt (O)
and 5/8" Lock Nut (P). The Crank (E) may
need to be extended to align the bolt holes.
Tighten hardware snug against Lower Arm (C)
and the tabs on the Pole (B), then back off 1/2
turn. See Figure 8.
10. Attach Upper Arms (D) to the Pole (B) using a
5/8" X 11" Hex Bolt (N) and 5/8" Lock Nut (P).
Tighten hardware then back off 1/2 turn. This is
a pivot point, do not over tighten. See Figure 9.
Package
Backboard
HT6072G &
BA42GHT
PR98GHT
PR98UHT
BA42UHT
HT6060G
BA487
HT6060GSM
BA487SM
PR98UHTJR
BA487U
PR98SHT
BA47U
PR98SXLHT
BA472
11. Look at the table above to determine which
instructions to follow for assembly of the
Backboard (X).
For the following packages: HT6060G, HT6060GS, PR98UHTJR, PR98GHTJR
1. Use the 5/16" X 1" Machine Screws (Z), 5/16" Lock
Washers (AA) and 5/16" Hex Nuts (BB) to install
Backboard H-Frame (Y) into Backboard (X).
See Figure 10.
2. Once Backboard (X) is assembled refer to
instruction 12 to complete system assembly.
Required H-Frame
HT6HFRAME2
HT6HFRAME2
HT5HFRAME2
HT5HFRAME2
HT5HFRAME2
PR98SHTBKT2
(hardware packed with frame)
PR98SHTBKT2
(hardware packed with frame)
HT5HFRAME2
Figure 8
Figure 9
Figure 10
4
Advertisement
