SpringWell CSF+ Setup And Installation Manual page 6

CSF+ Whole House Filter/Salt Free Softener
Assembling a Bypass Valve
Note: The tanks do not have a built-
in bypass valve. Therefore you will
need to build a bypass to allow for
easy system maintenance.
Recommended Supplies
1.5-inch Tee
Connector (Slip) (x2)
Primer and Cement
* The quantities are suggestions. Your system configuration may vary depending on installation area.
13) Prior to working with the
pre-plum you must ensure the
water to the main has been shut
off.
Bypass on. No water flow to
system
1.5-inch Elbow
Connector (Slip) (x4*)
1.5-inch PVC Pipe (Cut to fit)
14) Prep the pre-plumb and
identify the water flow
direction.
Questions? Call (800)-589-5592
Bypass Operation
1.5-Inch PVC Shut Off
Valves (x3)
Bypass off. Water flows
through system
1
2
IMPORTANT: The system will be
under pressure so all slip connections
must be primed (1) then cemented
(2) in place.
15) To keep the bypass accessible
it is recommended to work it
upwards. Start by connecting an
elbow to each connection
pointing them upwards.
6