Exploded View Of Convection System; Fan Blade; Mounting Plate Oven; Convection Fan Motor - Frigidaire GLEB30M9FSA Service Data Sheet

Electric wall oven with electronic oven control

Hide thumbs Also See for GLEB30M9FSA:

Table of Contents

LOWER OVEN INFORMATION

EXPLODED VIEW OF CONVECTION SYSTEM

CONVECTION FAN

MOTOR ASSEMBLY

The fan blade is mounted in the rear of the unit and has a "D" shaped mounting hole. Only minimum clearance exists

between the oven back, fan blade, and fan shroud. Be careful not to bend blade when removing or installing.

Access to the fan blade is gained by removing the fan shroud, held in place by three screws, from the inside of the oven.

The fan blade is held in place with a hex nut that has left handed threads. When removing this nut, gently hold the

fan blade, and turn the nut clockwise. If one of the blades becomes deformed, it may be bent back into shape using

a flat surface as a reference.

A flat washer is located on the motor shaft between the snap ring on the shaft and the fan blade.

NOTE:If the fan blade is bent and motor vibrations increase, the noise made by the fan will be greater.

The fan motor on the rear of the unit is mounted to the main back (with three screws). There is a mounting plate held

in place between the main back (with 2 screws) and the rear oven wall (with 2 screws). Should it be necessary to replace

the oven cavity, you must remove the 2 screws located inside the unit at the rear of the oven cavity.

The 120 volt fan motor is located on the outside of the rear of the oven.

MOUNTING PLATE

OVEN CAVITY

CONVECTION

FAN BLADE

CONVECTION

FAN COVER

FAN NUT

CONVECTION

ELEMENT

FAN COVER

SCREWS

Table of Contents