Frigidaire GLEB30M9FSA Service Data Sheet page 11

LOWER OVEN INFORMATION
OVEN DOOR REMOVAL AND REPLACEMENT
To Remove the Oven Door:
1. Open the door to the fully opened position.
2. Pull up the lock located on each hinge support and engage it in the hinge lever. You may have to apply a little
downward pressure on the door to pull the locks fully over the hooks.
3. Grab the door by the sides, pull the bottom of the door up and toward you to disengage the hinge supports.
Keep pulling the bottom of the door toward you while rotating the top of the door toward the range to com-
pletely disengage the hinge levers.
To Replace the Oven Door:
1. Grab the door by the sides; place the hinge supports in the hinge slots. Open the door to the fully opened
position.
2. Disengage the lock from the hinge levers on both sides.
Note: Make sure the hinge supports are fully engaged before unlocking the hinge levers.
3. Close the oven door.
The door is heavy. After removing door, lay it flat on the floor with the inside of the door facing down.
Hinge
lever
Hinge
support
Lock in normal position
"HIDDEN BAKE" COVER REMOVAL AND REPLACEMENT (SOME MODELS)
"
To remove the "hidden bake" cover:
1. In order to remove the "hidden bake" cover, pull the back
edge with one hand about 1/2" inch and lift up the "hidden
bake" cover with both hands. (See picture)
2. When re-installing the "hidden bake" cover, be sure to put it
all the way to the back of the oven and lay it down on the 2
shoulder screws. Then push the front edge of the cover in its
place below the front bracket.
To have easier access to the oven floor, you can remove the oven
door by following the instructions above.
IMPORTANT: Always replace the "hidden bake" cover before the
next use.
Lock engaged for door
removal
11
HINGE SLOT
Door removed
from the range