Page 3
Do not remove power supply or control cord. All electrical and motor repairs and service must be performed by the factory or a repair facility approved by Liberty Pumps and certified to Check 3-phase pumps for correct rotation prior to installing work on explosion-proof motor enclosures.
Page 4
Contact Liberty Pumps customer service to report any damage or These pumps are to be used for handling septic tank shortage of parts. effluent and drain (storm) water.
Page 5
Intrinsically safe control panels designed for use with the Intrinsically safe (ISS and ISD Series) panels by Liberty Pumps have XFL-Series pumps available from Liberty Pumps can be found at a seal leak test button that tests the integrity of the seal leak http://www.LibertyPumps.com/Portals/0/Files/...
Page 8
Larger pipe sizes may be required to eliminate friction handling or making any adjustments to either the pump(s), the pump system, or the control panel. head loss over long runs. Contact Liberty Pumps or other qualified person if there are questions regarding proper pipe size and flow rates.
Page 9
To keep the pump/pump system operating smoothly, perform the Otherwise, the pump must be returned to Liberty Pumps or an following routine checks: authorized hazardous repair facility for electrical and motor service.
Page 10
Motor stops and then restarts after short Pump operating on a short cycle due to basin period but overload A larger basin may be required. Consult Liberty Pumps. being too small. heaters in starter do not trip. Improper float switch setting.
Page 12
Liberty Pumps, Inc. shall not be liable for any loss, damage, or expenses resulting from installation or use of its products, or for indirect, incidental, and consequential damages, including costs of removal, reinstallation or transportation.
Need help?
Do you have a question about the XFL Series and is the answer not in the manual?
Questions and answers