Advertisement
Step 16
Place the roof (9) into the grooves of the walls (8,14). Once in place, start the top
two washer (11) and locknuts(5) onto the threaded rods (12). Using your wrench,
hold the interior nut assembly (1) from moving. Then tighten the locknut (5) until
the roofline starts to bow. Make sure the roof tongues are in the grooves of the
walls. Repeat this for the other threaded rod. Tighten the jams nut (3) against the
interior wall nut assemblies (1) on the interior wall (8).
Step 17
Insert hex head bolts(6 &13) with the washers (4) through the walls and roof.
Place a 3/8 washer (4) and a locknut (5) on the end of the bolt. Tighten bolts
securely to draw the sidewalls and roof together (there should not be a gap
between the roof and walls in this area). Wipe off or smooth out any sealant that
may have squeezed out of the seams. Note: Hex head bolt (13) goes on the end
wall.
23
Advertisement
