Advertisement
PLEASE READ ASSEMBLY INSTRUCTIONS CARFULLY
Step 1
Remove the roll door (18) by pulling the bottom edges through the notches in the
walls until it comes out the whole way. Repeat for the opposite side. Take a pair
of channel locks or pliers and pull out the hinge pin tube (17) from the hinged
door (15 or 16). Repeat for the other three doors.
Step 2
Remove the top two bolts (6 & 13) that fasten the roof to the walls.
(See Figure 1) Make sure to save this hardware. It will be needed later in the
assembly.
16
Advertisement
