Advertisement
Step 8
Place the roof (9) into the interior wall grooves. Once the roof is into the grooves,
thread the top two interior wall nut assemblies (1) onto the threaded rods (2).
Using a 9/16 wrench, hold the interior wall nut assembly (1) on the interior wall
(8) from turning, while using a 9/16 socket and ratchet on the outside of the other
interior wall. Tighten the unit until the roofline starts to bow. Make sure the roof
tongues are in the grooves of the walls. Repeat for the other interior wall nut
assembly (1). Tighten the four jam nuts (3) to the interior wall nut assemblies (1)
on the top two threaded rods(2).
Step 9
Insert hex head bolt(6) with the washer (4) through the interior wall and roofs.
(Do not insert a hex bolt (6) on the outer interior wall unit, until the next unit is
added on.) Place a 3/8 washer (4) and a locknut (5) on the end of the bolt.
Tighten bolt securely to draw the sidewall and roof together (there should not be a
gap between the roof and sidewall in this area). Wipe off or smooth out any
sealant that may have squeezed out of the seams.
19
Advertisement
