Advertisement
Step 14
Slide the pallet (7) back into place. Take the end wall (14) and place into position
on the pallet (7) sliding the threaded rods through the end wall holes . Place a
washer (11) and locknut (5) onto the 2 bottom threaded rods (12) and tighten until
the wall is secure and won t fall. Then slide the top two threaded rods(12) through
the end wall with the washer (4) and locknut (5) attached to the end.
Step 15
Thoroughly caulk (23) both the center wall (8) and sidewall (14) the full length
and depth of the groove that mates with the roof tongue. Caulk as shown in the
photograph.
22
Advertisement
