ABB MAG-X 3000 Series Instruction Manual page 2

The following are trademarks of ABB Automation:
The following is a registered trademark of E. I. du Pont de Nemours and Company:
The following is a trademark of Haynes International Incorporated:
The following is a trademark of International Nickel Company, Incorporated:
WARNING notices as used in this manual apply to hazards or unsafe practices which could result in personal
injury or death.
CAUTION notices apply to hazards or unsafe practices which could result in property damage.
NOTES highlight procedures and contain information which assist the operator in understanding the information
contained in this manual.
All software, including design, appearance, algorithms and source codes, is owned and copyrighted by ABB
Automation and is owned and copyrighted by ABB Automation or its suppliers.
POSSIBLE PROCESS UPSETS
Maintenance must be performed only by qualified personnel and only after securing equipment controlled
by this product. Adjusting or removing this product while it is in the system may upset the process being
controlled. Some process upsets may cause injury or damage.
The information contained in this document is subject to change without notice.
ABB Automation, its affiliates, employees, and agents, and the authors of and contributors to this
publication specifically disclaim all liabilities and warranties, express and implied (including warranties of
merchantability and fitness for a particular purpose), for the accuracy, currency, completeness, and/or
reliability of the information contained herein and/or for the fitness for any particular use and/or for the
performance of any material and/or equipment selected in whole or part with the user of/or in reliance upon
information contained herein. Selection of materials and/or equipment is at the sole risk of the user of this
publication.
This document contains proprietary information of ABB Automation, and is issued in strict confidence. Its
use, or reproduction for use, for the reverse engineering, development or manufacture of hardware or
software described herein is prohibited. No part of this document may be photocopied or reproduced
without the prior written consent of ABB Automation.
WARNING
NOTICE
Copyright 2001 ABB Automation [March 2001]
COPA-XM
®
MAG-X
®
TEFLON
HASTELLOY
MONEL