CONTENT lmportant Safe g uar d s - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - D es c r i p ti o n - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - 3 P re pa rin g Far U s e - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - 4 Des cri ption Of The Dis p l a y Screen - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - 5...
Page 3
IMPORTANT SAFEGUARDS • Use this appliance only as described in this instruction manual. As with all electrical equip ment, whilst the instructions aim to cover as many eventualities as possible, caution and common sense should be applied when operating and installing this appliance. •...
Page 4
lmportant information for correct disposal of the product in accordance with EC Directive 2002/96/EC. At the end of its working life, the product must not be disposed of as urban waste. lt must be taken to a special local authority differentiated waste collection centre or to a dealer providing this service.
PREPARING FOR USE The instructions below will enable you to prepare your air condi tioner far operation as efficiently as possible. Befare use, make sure the air intake and outlet grilles are unob structed. AIR-CONDITIONING WITHOUT INSTALLATION Just a few simple steps and your comfort is ensured with your appliance: •...
DESCRI P TION OF THE DISPLAY SCREEN -•- �·# #.� 1 COOL symbol 4 TIM ER symbol 2 HEAT symbol 5 Temperature symbol 3 FAN Speed indicator 6 Temperature indicator OPERATING FROM THE CONTROL PANEL The control panel is on the top of the appliance, enables you to manage part functions without remate controller, but to fully exploit its potential, you must use the remate controller.
Page 8
TURNING THE APPLIANCE ON Plug into the mains socket, then the appliance is standby. Press the (.!) button to make the appliance turn on. The last function active when it was turned off will appear . Never turn the air conditioner off by unplugging from the mains. Always press the button (!), then wait for a few minutes before unplugging.
Page 9
• Water is removed from !he air and collected in !he tank . • When !he tank is full, !he appliance shuts down and " F� " (full tank) appears on !he display. The tank cap mus! be extracted and emptied. Run off all water left into a basin. When all the water has been drained, put the cap back in place.
Switch the unit of temperatura When the appliance is standby, press the M button 20 seconds, then you can change the unit of temperature. For example: Befare change, in cool mode, the screen display like fig1. After change, in cool mode, the screen display like fig2. �u·c •...
MANUALOFREMOTECONTROL Fan bullan � Poinl !he remole control al !he receiver on !he appliance. The remole control mus! be no more !han 7 metras away ó Swing bullan from !he appliance (without obstacles between !he remole � control and !he receiver). Sleep bullan �...
Page 12
DFANMODE When using the appliance in this mode, the air hose does not need to be attached. To set this mode correctly: • Press the M button a number of times until the :: :: symbol appears. • Select the required fan speed by pressing the � bullan. •...
Page 13
P 1--+ P 2--+ P 3--+ Swing SWING FUNCTION This function is useful far select the up/down swing of air delivery. The de/lector position To set this function correctly: �{La�¡ • Select the operating mode (cool, dry, fan,heat) as described above. •...
TIPS FOR CORRECT USE To get the best from your air conditioner, follow these recom mendations: • Glose the windows and doors in the room to be air conditio ned (fig. 21 ). When installing the air conditioner semi-perma nently, you should leave a door slightly open (as little as 1 cm) clase to guarantee correct ventilation.
Page 15
INTERMITTENT DRAINAGE(fig.24 and fig.25) • Turn the air conditioner off, then drain the water tank by unplugging the drain cap and allowing the water to flow onto the drain pan. The drain pan will not hold !he full contents of !he water tank. A number of fills of the drain pan are required.
CLEANING Befare cleaning or maintenance, turn the appliance off by pressing the (!) button on the control panel or remate control, wait for a few minutes then unplug from the mains socket. CLEANING THE CABINET You should clean the appliance with a slightly damp cloth then dry with a dry cloth. Never wash the air conditioner with water.
START - END OF SEASON OPERATIONS START OF SEASON CHECK$ Make sure the power cable and plug are undamaged and the earth system is efficient. Follow the installation instructions precisely. END OF SEASON OPERATIONS To empty the interna! circuit completely of water, remove the cap ( fig.
TROUBLESHOOTING PROBLEM CAUSE SOLUTION • there is no current • wait The air conditioner does not come on • it is not plugged into the mains • plug into the mains • the interna! safety device has • wait 30 minutes, if the problem tripped persists, contact your service cen...
Page 19
C./ Industria, 13 l Polígono Industrial El Pedregar 08160 Montmeló Barcelona (Spain) Phone: (0034) 93 390 42 20 Fax: (0034) 93 390 42 05 info@giatsu.com www.giatsu.com...
Need help?
Do you have a question about the Giatsu P15 and is the answer not in the manual?
Questions and answers