When Not In Use; Overloading; Optional Equipment; Small Accessories - AOC 32S5285 Manual

When Not in Use

If you will not be using the TV set for several days, the
TV set should be disconnected from the AC power outlet
for environmental and safety reasons. The TV set is not
disconnected from the AC power source when the TV set
is switched off. To disconnect the TV set completely, pull
the plug from the AC power outlet.

Overloading

This TV set is designed to operate on a 110-240V
AC supply only. Take care not to connect too many
appliances to the same AC power outlet as this could
result in a fire or an electric shock.

Optional Equipment

Do not install optional equipment too close to the TV set.
Keep optional equipment at least 11.875 inches (30 cm)
away from the TV set. If a VCR is installed in front of the
TV set or beside the TV set, the picture may become
distorted. Picture distortion and/or noisy sound may
occur if the TV set is positioned in close proximity to any
equipment emitting electromagnetic radiation.

Small Accessories

Keep small accessories out of children's reach.

Antennas

Outdoor antenna grounding
If an outdoor antenna is installed, follow the precautions
below. An outdoor antenna system should not be located
in the vicinity of overhead power lines or other electric
light or power circuits, or where it can come in contact
with such power lines or circuits.
WHEN INSTALLING AN OUTDOOR ANTENNA
SYSTEM, ExTREME CARE SHOULD BE TAKEN TO
KEEP FROM CONTACTING SUCH POWER LINES
OR CIRCUITS AS CONTACT WITH THEM IS ALMOST
INVARIABLY FATAL.
Be sure the antenna system is grounded so as to provide
some protection against voltage surges and built-up static
charges.
Section 810 of the National Electrical Code (NEC)
in USA and Section 54 of the Canadian Electrical
Code in Canada provides information with respect to
proper grounding of the mast and supporting structure,
grounding of the lead-in wire to an antenna discharge
unit, size of grounding conductors, location of antenna
discharge unit, connection to grounding electrodes, and
requirements for the grounding electrode.
Antenna grounding according to the National
Electrical Code, ANSI/NFPA 70�
Antenna lead-in wire
Ground clamps
Electric service
equipment
Ground clamps
Power service grounding
electrode system

Batteries

 Do not dispose of batteries in a fire.
 Do not short circuit, disassemble or overheat the
batteries.
 Danger of explosion if battery is incorrectly replaced.
Replace only with the same or equivalent type.
 The batteries (batteries installed) shall not be exposed
to excessive heat such as sunshine, fire or the like.
Disposal of used batteries
To preserve our environment, dispose of used batteries
according to your local laws or regulations.
6
Antenna lead-in wire
Antenna discharge unit
Grounding conductors