Table of Contents
Advertisement
SET HOUSE ID
All LightSense™ wireless devices installed in the same home must acquire the
same unique House ID before use. This process is known as house binding.
Each LightSense wireless device is bound to all other LightSense wireless
devices in the house.
New Installation
1. With all devices installed and energized, make sure that every Lightsense
wireless device LED is yellow. If
any LED is off, be sure the circuit
breaker is on and the device is
correctly installed.
2. Press
on any device paddle
until the LED flashes yellow
(about 2 seconds). This indicates
that it has acquired a unique
House ID.
3. Make sure that all other LightSense wireless device LEDs are flashing
green, indicating that they have acquired the same House ID.
4. Return to the device used in step 2, which is still flashing yellow. Press
until the LED changes to solid green (about 2 seconds). All device LEDs in
the house change to solid green, indicating house binding is complete.
Adding a Device to an Existing Installation
If you're adding or replacing a device in a LightSense wireless installation that is
already operating, the new device must acquire the same House ID as the other
LightSense wireless devices in the house. After the new device is powered up,
the LED should be solid yellow. This indicates that it has not yet acquired a
House ID. To acquire the House ID for the existing system:
1. Press
on any previously bound device until the LED flashes yellow
(about 2 seconds).
2. Verify that the newly added device LED is flashing green, indicating that it has
acquired the House ID.
3. Return to the same previously bound device used in step 1 and press
until the LED changes to solid green (about 2 seconds). All device LEDs
should now be solid green.
Call 800.223.4185 for Technical Support
When you see
in the instructions,
firmly press and
hold both the top
and bottom of the
device paddle until
the LED changes
(about 2 seconds).
Advertisement
Table of Contents
