Table of Contents
Advertisement
340746_RevC_PSWCR.qxd:340746_RevC_PSWCR
TURN THE POWER OFF AT THE CIRCUIT BREAKER BEFORE
INSTALLING THE DIMMER.
INSTALLATION
For ease of installation, Pass & Seymour/Legrand recommends use of a deep
wall box.
1. Disconnect power to circuit by turning circuit breaker OFF before installation.
2. Remove existing wall plate and switch.
1
3. Strip existing wires
/
". If two wires will be connected to the same terminal
2
on a LightSense™ device, both wires must be the same gauge (12AWG or
14AWG).
4. Wire the LINE (black), NEUTRAL (white) and GND supply wires to the
correspondingly marked screw terminals, according to the wiring diagram.
5. Attach the wall plate.
6. Switch the circuit breaker back ON.
INSTALL IN COMPLIANCE WITH ALL APPLICABLE CODES &
STANDARDS. Failure to follow these instructions may cause
personal injury or equipment damage.
Visit our website for FAQs: www.passandseymour.com
10/23/08
CAUTION
10:49 AM
Page 7
Advertisement
Table of Contents
