Table of Contents
Advertisement
340746_RevC_PSWCR.qxd:340746_RevC_PSWCR
STANDARD OPERATION
The PSWCR is shipped with most functions preprogrammed for ease of
installation and initial use. This section summarizes the default operation of the
PSWCR. To make changes from this standard operation, such as changing
light levels and including or excluding devices from specific scenes, see
CUSTOMIZING OPERATION.
Paddle Functions
Use the rocker paddle to begin and end binding functions. It also functions as
an On/Off switch and a master light level Raise/Lower control for the room. All
devices bound to the same room as the PSWCR are included in the paddle
operation (except fan controls).
Scene Button Functions
The smaller buttons, labeled A–E in the illustrations, are used to record and
recall scenes. Labels are provided so that you can name these buttons to suit
your application. All devices bound to the same room as the PSWCR are
included in each scene button (except fan controls).
The following illustration shows the default operation for scene set 1-5.
Paddle
NOTES:
1
Pressing and holding the paddle does not affect the operation of switched
devices. They will maintain their present state.
2
If the lights were turned off using the default E scene button or any
customized scene button programmed for 0%/ALL OFF, pressing and
holding
will not raise the light level. It will raise the light level if the lights
were turned off by tapping
3
Scene buttons on PSWCR controllers with scene set 6-10 or 11-15 are
preprogrammed to turn off all room devices.
Visit our website for FAQs: www.passandseymour.com
10/23/08
Scene Buttons
3
.
10:49 AM
Page 10
Advertisement
Table of Contents
