Table of Contents
Advertisement
340746_RevC_PSWCR.qxd:340746_RevC_PSWCR
TROUBLESHOOTING
During house ID binding, the LED is not flashing on some devices.
•
If LED is solid green before initiating House ID binding:
The device already has another House ID. Reset it to the factory default
so that it can be bound to the desired House ID. Resetting to factory
defaults is described in "I made a configuration mistake. I need to start
over."
•
If LED is solid yellow after initiating House ID binding:
The device may be out of range of the initiating device. Add a PSWO
Wireless Repeater to boost signal range.
During binding or customizing, all LEDs stop flashing before I press
The 5 minute binding process timer may have expired. Restart the timer by
repeating steps 1 and 2 of the procedure you were using. Notice that the
devices you previously excluded are flashing green; those included are
flashing yellow; simply finish the process from where you left off.
The device LED flashes red when I press
The house or room configuration may be locked.
Go to any house level scene controller and simultaneously press
buttons B and E until the scene controller LED flashes GREEN.
Go back to the previously locked device and press
•
If it flashes green or yellow, you have unlocked the house configuration.
•
If the device still flashes red, the configuration may be locked
by a room level scene controller such as the PSWCR or PSWRR.
Go to the room scene controller and simultaneously press
and E until the scene controller LED flashes GREEN. (See LOCK ROOM
CONFIGURATION.)
Go back to the previously locked device and press
•
If it flashes green or yellow, you have unlocked the room configuration.
•
If the device still flashes red, the configuration may be locked by another
room level scene controller in the house. Repeat the procedure from
different controllers until the device is no longer flashing red.
I made a configuration mistake. I need to start over.
To reset any LightSense™ wireless device to factory default settings, press
and hold -
- until the LED changes to solid yellow (approximately 10
seconds). During the process, the LED flashes yellow. When complete, it
becomes solid yellow. The device can then be reconfigured, exactly like any
new device.
10/23/08
10:49 AM
.
.
and
.
and buttons B
.
Page 3
Advertisement
Table of Contents
