Carrier XPower Owner's Manual page 21

Standard swing
All four louvers swing simultaneously at the same
angle.
Swing
Dual swing
Adjoining louver alternately swing horizontally and
downward.
Horizontal
Horizontal
Downward
Downward
Horizontal
Horizontal
Downward
Downward
39-EN
1115350277.indd 21
Cyclic swing (Recommended for cooling)
All four louvers swing at different times like waves.
Setting the louver lock
1
button (right side of
Push and hold the UNIT LOUVER
the button) for at least 4 seconds while
running is stopped.
blinks.
• When no unit number is displayed, all units are
selected.
2
Push the button (left side of the button)
to select a unit.
The unit number changes each time you push the
button.
Unit No. Unit No. Unit No.
1-1 1-2 1-3
Unit No.
1-4
The fan of the selected unit runs, and the louver
swings.
3
Push the "TEMP. " buttons to
display the number of the louver to fix its
direction.
The selected louver swings.
4
Push the buttons to select the
direction of the louver you do not want to
swing.
(1) (2) (3)
0001 0002 0003
(4) (5)
0004 0005
* If (4) or (5) is selected, condensation may occur
during cooling.
5
Push the button to confirm the setting.
When the setting is confirmed, the mark lights
up.
(To set the louver lock of another unit, repeat from
Step 2. To set another louver lock of the same unit,
repeat from Step 3.)
6
Push the button to finish the setting.
– 20 –
0001 - 0005
(Louver position
Louver No.
code)
* F1 appears in the CODE No. section on the
remote controller. This indicates that the louver
01 shown in the following figure is selected.
Electrical control box
03
Refrigerant
pipe
04 02
Drain pipe
01
NOTE
Even in louver lock mode, the louver temporarily
moves in the following cases:
• When the air conditioner is stopped
9/27/2018 8:57:14 AM
EN
EN
40-EN