Table of Contents
Advertisement
Limitless™ WLS Series
Single Switch Adapter
1.4
Pairing Mode
Pairing is required to initiate and establish an RF communication link between each single WLS Single Switch Adapter and a single
WPMM or WDRR. The WLS Single Switch Adapter will be shipped from the factory with two identification labels (1) that are recom-
mended to be completed and applied to the WLS Single Switch Adapter housing during the pairing mode. As there are up to 16 WLS
Single Switch Adapter devices that can be paired to a single WPMM or WDRR, these labels will be used to identify the WLS Single
Switch Adapter in the sequence of #1 to #16. The initial WLS Single Switch Adapter paired to the WPMM or WDRR will be Sequence
#1; the second WLS Single Switch Adapter paired will be Sequence #2 and so on. If replacing a WLS Single Switch Adapter that has
been purged (as applicable, see section 6.5 of the WPMM Installation and Technical Manual or Section 7.3 of the WDRR Installation
and Technical Manual), identify the correct replacement Sequence # on the identification labels.
Pairing steps when using a WPMM: The battery will need to be activated in the WLS Single Switch Adapter and proper power ap-
plied to the WPMM (green LED illuminated) before proceeding with this pairing procedure. Once the pairing is completed, the WLS
Single Switch Adapter selected will only communicate with the WPMM it was paired to and no other device.
Step
Action
1
Completely read this procedure before starting in order to understand the timing of events that need to be performed.
2
WLS Single Switch Adapter: Remove (if required) the two screws on the housing cover (See Figure 3, page 4) of the
WLS Single Switch Adapter and locate the function button to be used in Step 4.
3
WPMM: Press the Function button on WPMM (See Figure 4, page 5) for more than four seconds and less than eight
seconds at which time the green and yellow LEDs will be flashing which indicates to release the function button im-
mediately as it has entered the pairing mode.
4
WLS Single Switch Adapter: Within a 30 second interval of Step 3, depress the WLS Single Switch Adapter switch function
button (See Figure 10, page 8) and hold depressed for more than one second and less than 12 seconds at which time
the orange LED turns on. While in pairing mode, the orange led will flash on for 100 ms every second. The orange
LED flashes three times 100 ms on, 100 ms off when pairing succeeds. If pairing does not succeed, the orange LED will
turn off and user will need to repeat steps starting with Step 3.
5
WPMM: Successful pairing will be indicated by the green and yellow LEDs (See Figure 9, page 8) ceasing to flash
and remaining on for a few seconds before turning off. A short buzzer beep will also occur.
6
To confirm proper pairing between the WLS Single Switch Adapter and WPMM, actuate the user-supplied switch, and the
red LED should illuminate along with a buzzer sound.
7
Record the WLS Single Switch Adapter Sequence # on identification labels † and apply to the WLS Single Switch Adapter
housing in desired locations (See Figure 11, page 8).
8
Repeat Steps 2-7 to add additional WLS Single Switch Adapter units switches. Up to 16 WLS Single Switch Adapters can
be paired to a single WPMM.
50081314
ISSUE 1
Honeywell Sensing and Control
7
Advertisement
Table of Contents
