Table of Contents
Advertisement
Limitless™ WLS Series
Single Switch Adapter
1.5
Antenna Adjustment
The antenna of the WLS Single Switch Adapter and WPMM or WDRR should be oriented with respect to each other such that they are
parallel. This will in most cases allow the longest range and highest RF communication link/signal. The least RF signal is normally in
a direction in-line with the top of the antenna, so it is best to avoid having the antennas pointed directly toward each other, or directly
away from each other. An acceptable RF signal is also indicated by the RF signal strength LEDs on the WDRR; see the WDRR Installa-
tion and Technical Manual for further information.
Figure 14. Limitless™ WLS Single Switch Adapter and WPMM in Parallel
m WARNING
RF EXPOSURE
To satisfy FCC RF exposure requirements for mobile transmitting devices, a separation distance of 20 cm [7.87 in] or more should
be maintained between the antenna of this device and persons during device operation. To ensure compliance, operations at
closer than this distance is not recommended. The antenna used for this transmitter must not be co-located in conjunction with any
other antenna or transmitter.
Failure to comply with these instructions could result in death or serious injury.
12
Honeywell Sensing and Control
50081314
ISSUE 1
Advertisement
Table of Contents
