Honeywell Limitless WLS Series Quick Start Manual page 3

Limitless™ WLS Series
Single Switch Adapter
Step 1: Each conductor color in the user-supplied cable needs to be connected to the end-user supplied switch as follows (see Fig-
ure 1 as an example):
BROWN wire: Connect to common terminal of the user-supplied switch
BLACK wire: Connect to normally open terminal of the user-supplied switch
BLUE wire: Connect to normally closed terminal of the user-supplied switch
Figure 1. Limitless™ WLS Single Switch Adapter BT1 & BT2 Conductor to Switch
Step 2: Connect the mating connector w/cable to the WLS Single Switch Adapter M12 connector and then tighten
connector (see Figure 2)
Figure 2. WLS Single Switch Adapter BT1 & BT2 Connector to Mate Cable
50081314
ISSUE 1
Honeywell Sensing and Control 3