Battery Connection Procedure - Honeywell Limitless WLS Series Quick Start Manual

Limitless™ WLS Series
Single Switch Adapter
Figure 4. WLS Single Switch Adapter BT3 & BT4 Switch
Term and Wires
1.3

Battery Connection Procedure

m WARNING
RISK OF DEATH OR SERIOUS INJURY FROM EXPLOSION OR FIRE
Connection and disconnection of the batteries should only be performed in a non-hazardous area. The batteries used in this
device may present a risk of fire or chemical burn if mistreated. Do not recharge, disassemble, heat above 100 °C [212 °F], or
incinerate.
Failure to comply with these instructions could result in death or serious injury.
m WARNING
RISK OF DEATH OR SERIOUS INJURY FROM EXPLOSION OR FIRE
If WLS Single Switch Adapter is to be returned to Honeywell for any reason, the battery MUST be removed prior to shipping.
Dispose of used batteries promptly per local regulations or the battery manufacturer's recommendations. Keep away from
children. Do not disassemble and do not dispose of in fire.
Failure to comply with these instructions could result in death or serious injury.
, ATTENTION
RISK OF DEATH OR SERIOUS INJURY FROM EXPLOSION OR FIRE
Use only the following 3.6 V lithium thionyl chloride (Li-SOCl2) battery (non-rechargeable), size 2/3 AA. No other batteries are
approved for use in the WLS Single Switch Adapter.
• Uniwell, DEV-10-0009
• Green Energy, ER14335M
• Honeywell, WBT1
Figure 5. WLS Single Switch Adapter BT3 & BT4 WECO
Connector Term and Wires
50081314
ISSUE 1
Honeywell Sensing and Control 5