Electrolux W565H Installation Manual page 38

38
Mount the nipple to the steam valve. Mount the steam valve on the machine. Mount nipple, strainer and elbow. Note
the direction of the strainer. Mount steam hose to the elbow. Check that there are no sharp angles or bends on the
connected steam hose.
Mount the hose with wires between steam valve and machine. Connect the wires to the steam valve. Connect ground
cable to the terminal ground connection. Connect the "HEAT" cable connector to the "HEAT" terminal on the I/O
board.
"HEAT"
Steam pressure required:
• minimum: 50 kPa (0.5 kp/cm
• maximum: 800 kPa (8 kp/cm
• recommended: 600 kPa (6 kp/cm
Note!
A steam heated machine is only intended to use clean steam.
Installation manual
2 )
2 )
2 )
fig.5862C
fig.6604B