Mercedes-Benz S-Class Maybach Owner's Manual page 375

372 Breakdown assistance
372
Please note that tyre sealant may leak out when
unscrewing the lling hose.
Drive forwards or in reverse very slowly for
#
approximately 10 m.
Pump up the tyre again.
#
A er a maximum of ten minutes the tyre pres-
sure must be at least 200 kPa (2.0 bar/
29 psi).
& W W ARNING
ARNING Risk of accident due to the
speci ed tyre pressure not being attained
If the speci ed tyre pressure is not attained
a er the speci ed time, the tyre is too badly
damaged. The tyre sealant cannot repair the
tyre in this instance.
The braking and driving characteristics may be
greatly impaired.
Do not continue driving.
#
Consult a quali ed specialist workshop.
#
If, If, a er a er t t en minut en minutes, a tyr es, a tyre pr e pressur essure of 200 kPa
(2.0 bar/29 psi) has been att (2.0 bar/29 psi) has been attained: ained:
Switch o the tyre in ation compressor.
#
Unscrew the lling hose from the valve of the
#
defective tyre.
& W W ARNING
ARNING Risk of accident from driving
with sealed tyres
A tyre temporarily sealed with tyre sealant
impairs the handling characteristics and is not
suitable for higher speeds.
Adapt your driving style accordingly and
#
drive carefully.
Do not exceed the maximum speed limit
#
with a tyre that has been repaired using
tyre sealant.
Observe the maximum permissible speed for a
#
tyre sealed with tyre sealant 80 km/h.
* N N O O TE TE Staining from leaking tyre sealant
A er use, excess tyre sealant may leak out
from the lling hose.
e of 200 kPa
Therefore, place the lling hose in the
#
plastic bag that contained the TIREFIT
kit.
+
ENVIR ENVIRONMENT ONMENTAL NO AL NOTE TE Environmental
pollution caused by environmentally irre-
sponsible disposal
Tyre sealant contains pollutants.
Have the tyre sealant bottle disposed of
#
professionally, e.g. at a Mercedes-Benz
Service Centre.
Stow the tyre sealant bottle and the tyre in a-
#
tion compressor.
Pull away immediately.
#
Stop driving a er approximately ten minutes
#
and check the tyre pressure using the tyre
in ation compressor.
The tyre pressure must now be at least
130 kPa (1.3 bar/19 psi).
& W W ARNING
ARNING Risk of accident due to the
speci ed tyre pressure not being attained
If the speci ed tyre pressure is not reached,
the tyre is too badly damaged. The tyre seal-
ant cannot repair the tyre in this instance.