Mercedes-Benz S-Class Maybach Owner's Manual page 226

Synchr hronising t Sync onising the r he rolling code olling code
R R eq equir uirements: ements:
The door system uses a rolling code.
R
The vehicle must be within range of the garage
R
door or door drive.
The vehicle as well as persons and objects are
R
located outside the range of movement of the
door.
Press the programming button on the door
#
drive unit.
Initiate the next step within approximately
30 seconds.
Press previously programmed button 1,
#
or 3 repeatedly until the door closes.
When the door closes, programming is com-
pleted.
% Please also read the operating instructions for
the door drive.
T T r r oubleshoo oubleshooting when pr ting when progr ogramming t amming the r
control ol contr
Check if the transmitter frequency of remote
#
control 5 is supported.
Replace the batteries in remote control 5.
#
Hold remote control
#
a distance of 1 cm to 8 cm front of the inside
rearview mirror. You should test every position
for at least 25 seconds before trying another
position.
Hold remote control
#
various distances in front of the inside rear
view mirror. You should test every position for
at least 25 seconds before trying another
position.
On remote controls that transmit only for a
#
limited period, press button
2
control 5
Angle the aerial line of the garage door opener
#
unit towards the remote control.
%
It is possible that older garage doors cannot
be operated using the remote control in the
inside rearview mirror even a er you have
successfully performed the measures descri-
he remote emote
bed above. If this is the case, contact the
®
HomeLink
5 at various angles from
5 at the same angles at
6 on remote
again before transmission ends.
Hotline.
Driving and parking 223
% Support and additional information on pro-
gramming:
On the HomeLink ® Hotline on (0) 08000
R
466 354 65 or +49 (0) 6838 907-277
On the Internet at https://
R
www.homelink.com
Opening or closing t Opening or closing the g he gar arag age door e door
R R eq equir uirements: ements:
The corresponding button is programmed to
R
operate the door.
Press and hold buttons 1,
#
door opens or closes.
If indicator lamp 4 ashes yellow a er
#
approximately 20 seconds: press and hold the
previously pressed button again until the door
opens or closes.
Clear Clearing t ing the g he gar arag age door opener memory e door opener memory
Press and hold buttons 1 and 3.
#
Indicator lamp 4 lights up yellow.
If indicator lamp 4 ashes green: release
#
buttons 1 and 3.
The entire memory has been deleted.
223
2 or 3 until the