Mercedes-Benz S-Class Maybach Owner's Manual page 374

A x part 1 of the TIREFIT sticker to the
#
instrument cluster within the driver's eld of
vision.
A x part 2 of the TIREFIT sticker near the
#
valve on the wheel with the defective tyre.
Pull plug 6 with the cable and hose
#
of the tyre in ation compressor housing.
Push the plug of hose
#
tyre sealant bottle
Place tyre sealant bottle
#
into recess 2
sor.
Remove the valve cap from valve
#
faulty tyre.
Screw lling hose
#
Insert plug 6
#
cle.
5 out
Switch on the ignition.
#
5 into ange 4 of
3 until the plug engages.
3 head downwards
of the tyre in ation compres-
7 on the
8 onto valve 7.
into a 12 V socket in your vehi-
Breakdown assistance 371
Switch on the tyre in ation compressor using
#
On/O switch 1.
The tyre is in ated. First, tyre sealant is pum-
ped into the tyre. The pressure may brie y rise
to approximately 500 kPa (5 bar/73 psi).
Do not switc Do no t switch h o o t t he tyr he tyre e in ation in ation com
during t dur ing this phase! his phase!
Let the tyre in ation compressor run for a
#
maximum of ten minutes.
The tyre should then have attained a tyre pres-
sure of at least 200 kPa (2.0 bar/29 psi).
If tyre sealant leaks out, make sure you clean the
a ected area as quickly as possible. It is prefera-
ble to use clean water.
If you get tyre sealant on your clothing, have it
cleaned as soon as possible with perchloroethy-
lene.
If, If, a er a er t t en minut en minutes, a tyr es, a tyre pr e pressur essure of 200 kPa
(2.0 bar/29 psi) has no (2.0 bar/29 psi) has not been att t been attained:
Switch o the tyre in ation compressor.
#
Unscrew the lling hose from the valve of the
#
defective tyre.
371
compr pressor essor
e of 200 kPa
ained: